Ceramic assembly vibrating bed

Vibrocompactarii tile installation method is based on the traditional method of assembling tiles, enhanced by the use of technologies, materials and modern machinery.

Thus, after preparation of the drill bit and mechanized casting forming the base layer will be installed ceramic tiles. They are mechanically compacted all directions, passing several times in length and width over the floor surface using Compaction rollers (or rolls vibrating plate). This method helps to achieve optimum mechanical properties of adhesive systems and to obtain a flat surface.

Unlike traditional assembly by hand using hammer vibration method of execution not only ensures perfect contact between ceramic tiles and screed layer support, but it's a process smoother and faster, leading to the development of the upper surface of a qualitatively .

In this method using special recipes dig, which extended during commissioning work and offering good characteristics of workability, as a result of the use of additives that intarzietorii plug and / or plasticisers.

Ensure that materials be used cement paste with the strength properties of at least 32.5 category EMC according to DIN EN 196 (Z 35 to DIN 1164). Additives must conform to DIN 4226 and DIN 1045. Generally, floor finishing materials to be used are: Pressed ceramic tiles according to DIN EN 176 and DIN 18 158.

Edges of plates should not exceed 25 inches in length and a plate surface should not exceed 650 cm2. Thickness chosen depends on expected loads and is not recommended to be less than 12 mm.

This type of floor is suitable for supermarkets, service automotive, industrial halls, warehouses.

Assembly rate is usually 250-400 m / day with a team of 8-10 employees.

The main benefit of this method is fast in execution.